Cisco Cisco Expressway
Expressway-C
Expressway-E
Rule name
Enter Route to VCS
Not applicable
Description
Enter Search VCS neighbor zone
Priority
Enter 100
Protocol
Any
Source
Any
Request must be authenticated
No
Mode
Alias pattern match
Pattern type
Suffix
Pattern string
Enter @vcs.domain
Pattern behavior
Leave
On successful match
Continue
Target
Neighbor zone to VCS
State
Enabled
4. Click Create search rule.
SIP trunks to Unified CM
Task 13: Configuring logging (optional)
The following configuration will enable event logs to be sent to an external logging server (using the SYSLOG
protocol).
protocol).
n
The Log level controls the granularity of event logging. 1 is the least verbose, 4 the most.
n
A minimum log level of 2 is recommended, as this level provides both system and basic signaling message
logging.
logging.
Expressway-E external logging server configuration requires additional firewall / NAT configuration – See
To configure a logging server:
1. Go to
Maintenance > Logging
.
2. Configure the fields as follows:
Expressway-C
Expressway-E
Log level
2
2
Remote syslog server 1: Address
Enter 10.0.0.13
Enter 10.0.0.13
Remote syslog server 1: Mode
IETF syslog format
IETF syslog format
Cisco Expressway Basic Configuration Deployment Guide (X8.5)
Page 30 of 56
Optional configuration tasks