Cisco Cisco Expressway
Configuring the trunk to Expressway to specify a list of
Expressway peers
Expressway peers
1. On Unified CM, go to
Device > Trunk
.
2. Select the previously configured Trunk.
3. Scroll down and configure the
SIP Information
fields as follows:
(Click + to obtain additional destination address entries.)
Destination address is an SRV
Ensure that this check box is not selected
Destination address 1 and
Destination port 1
IP address or DNS name of Expressway peer 1
5060 or 5061 depending on connectivity (TCP/TLS)
Destination address 2 and
Destination port 2
IP address or DNS name of Expressway peer 2
5060 or 5061 depending on connectivity (TCP/TLS)
Destination address 3 and
Destination port 3
IP address or DNS name of Expressway peer 3 – if it exists
5060 or 5061 depending on connectivity (TCP/TLS)
... up to Destination address 6 and
Destination port 6
... repeat up to IP address or DNS name of Expressway peer 6 –
where they exist
where they exist
4. Click Save.
5. Click Reset.
6. Click Reset.
Unified CM with Cisco Expressway (SIP Trunk) Deployment Guide (X8.1)
Page 34 of 40
Appendix 2: Connecting Unified CM to an Expressway cluster