Cisco Cisco ACNS Software Version 5.5 Technical Manual

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Configure
      Step−by−Step Instructions
 Verify
 Troubleshoot
 Related Information

This document provides a sample configuration to repair dead disk drives in the Opal platform on Cisco 7300
Series Content Engines (CE−7300s) or Cisco 4650 Content Distribution Managers (CDM−4650s).

There are no specific requirements for this document.

The information in this document is based on these software and hardware versions:

CDM−4650 that runs Application and Content Networking System (ACNS) 4.0 or later

• 

CDM−4650 with a Redundant Array of Inexpensive Disks (RAID) controller

• 

CE−7320 and CE−7320−DC that run ACNS 4.0 or later

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

In this section, you are presented with the information to configure the features described in this document.

Note: To find additional information on the commands used in this document, use the Command Lookup
Tool (registered customers only) .