Cisco Cisco 1 GHz GainMaker Amplifier Installation Guide
Chapter 2 Installation and Configuration
3 Install the reverse equalizer specified by the design print in the reverse equalizer
slot. For the exact location of the reverse equalizer, refer to the accompanying
illustration. For a list of available reverse equalizers, see Technical Information
(on page 93).
4 Install other options or accessories as desired, or proceed to
Installing the
Amplifier Module (on page 38).
To Install the Crowbar Surge Protector
Complete the following steps to install the crowbar surge protector in the amplifier.
1 Begin this procedure with the housing open. Refer to
1 Begin this procedure with the housing open. Refer to
To Open the Node Housing
(on page 19).
2 Remove the amplifier cover by loosening the amplifier cover screws.
3 Install the crowbar surge protector in the surge protector slot. Refer to the
illustration below.
Note:
Make sure that all pins on the crowbar surge protector bottom align with the
pin holes in the surge protector slot, allowing the surge protector to install flat
against the amplifier module.
34
OL-31156-01