Cisco Headend System Release 2.7 Installation Guide
Set Up the QAM
4013154 Rev C
125
Set Up the QAM
Setting Up the QAM
After creating the MPEG source, follow these instructions to set up the QAM.
1 From the DNCS Administrative Console, click Element Provisioning and then
1 From the DNCS Administrative Console, click Element Provisioning and then
select QAM. The QAM List window opens.
2 Double-click the BFS QAM. The Set Up QAM window opens.
3 On the Set Up QAM window, configure the Input Port field to ASI.
4 Configure the INPUT Transport Stream ID field with the same value that you
4 Configure the INPUT Transport Stream ID field with the same value that you
recorded as the TSID on the Set Up MPEG Source window in a previous
procedure, Creating an MPEG Source (on page 122).
procedure, Creating an MPEG Source (on page 122).