Cisco Headend System Release 2.7 Installation Guide
Chapter 3 System Release 4.0 SP2 Installation Procedures
60
4013154 Rev C
Restart the Application Server at Aptiv Sites
Introduction
Follow this procedure only if the site you are upgrading supports the Aptiv
Application Server. If the site you are upgrading supports the Cisco Application
Server, skip this section and go to Restart the Billing and Third-Party Interfaces (on
page 61).
Application Server. If the site you are upgrading supports the Cisco Application
Server, skip this section and go to Restart the Billing and Third-Party Interfaces (on
page 61).
Restarting the Application Server at an Aptiv Site
Follow these instructions to check if the Aptiv application has started on the
Application Server, and then to start it, if necessary.
1 If necessary, open an xterm window on the Application Server.
2 Type CheckServices and then press Enter. A list of drivers appears.
Application Server, and then to start it, if necessary.
1 If necessary, open an xterm window on the Application Server.
2 Type CheckServices and then press Enter. A list of drivers appears.
Note: Each driver is associated with an Application Server process.
3 Does the word Yes appear next to each driver?
If yes, skip the rest of this procedure and go to Restart the Billing and Third-
Party Interfaces (on page 61).
Party Interfaces (on page 61).
If no, go to step 4.
Note: The word Yes next to a driver indicates that the process has started.
4 Press the middle mouse button, and then select Passport Start.
5 When the word Yes appears next to each driver, go to step 6.
6 Follow the on-screen instructions to close the window containing the list of Aptiv
5 When the word Yes appears next to each driver, go to step 6.
6 Follow the on-screen instructions to close the window containing the list of Aptiv
drivers.