Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Maintenance Manual

Class Map

Cisco WAP150 and WAP361 Administration Guide

133

-

Select From List—Matches the selected protocol: IPv6, ICMPv6, TCP, 
UDP.

-

Match to Value—Matches a protocol that is not listed by name. Enter the 
protocol ID. The protocol ID is a standard value assigned by IANA. The 
range is a number from 0 to 255.

•

Source IPv6—Requires a packet's source IPv6 address to match the IPv6 
address defined in the appropriate fields.

-

Source IPv6 Address—Enter the IPv6 address to apply this criteria.

-

Source IPv6 Prefix Length—Enter the prefix length of the source IPv6 
address.

•

Source Port—Includes a source port in the match condition for the rule. The 
source port is identified in the datagram header. 

-

Select From List—Matches a keyword associated with the source port: 
ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these keywords 
translates into its equivalent port number.

-

Match to Port—Matches the source port number in the datagram header 
to an IANA port number that you specify. The port range is from 0 to 
65535 and includes three different types of ports:

0 to 1023—Well-Known Ports

1024 to 49151—Registered Ports

49152 to 65535—Dynamic and/or Private Ports

-

Mask—The port mask. The mask determines which bits are used and 
which bits are ignored. Only the hexadecimal digit (0 to 0xFFFF) is 
allowed. 1 means the bit matters and 0 means that you should ignore this 
bit.

•

Destination IPv6—Requires a packet's destination IPv6 address to match 
the IPv6 address defined in the appropriate fields. 

-

Destination IPv6 Address—Enter the IPv6 address to apply this criteria.

-

Destination IPv6 Prefix Length—Enter the prefix length of the 
destination IPv6 address.

•

Destination Port—Includes a destination port in the match condition for the 
rule. The destination port is identified in the datagram header.