Cisco Cisco NAC Guest Server 1.0 Technical Manual
ISE SMS Notifications Setup for Sponsored Guest
Accounts
Accounts
Document ID: 116128
Contributed by Ben McAlary, Cisco TAC Engineer.;
Jun 07, 2013
Jun 07, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Caveats
Process
Related Information
Prerequisites
Requirements
Components Used
Caveats
Process
Related Information
Introduction
This document describes the process used to set up Short Message Services (SMS) notifications for sponsored
guest accounts. Cisco Identify Services Engine (ISE) uses an SMTP−to−SMS Gateway system. The ISE sends
an email to a Simple Mail Transfer Protocol (SMTP) server, which forwards the credentials via the SMS/SMS
Gateway:
guest accounts. Cisco Identify Services Engine (ISE) uses an SMTP−to−SMS Gateway system. The ISE sends
an email to a Simple Mail Transfer Protocol (SMTP) server, which forwards the credentials via the SMS/SMS
Gateway:
The email message is sent to a default destination (in this case sms@cisco.com).
•
Once the message arrives at the SMS gateway, the template is examined and the mobile number is
located.
located.
•
The SMS gateway then forwards the message to that number.
•
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
A basic knowledge of Cisco ISE procedures
•
A basic knowledge of the SMS/SMS Gateway system
•
Components Used
The information in this document is based on the Cisco SMTP−to−SMS Gateway system.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.