Cisco Cisco DX70 Design Guide
Cisco DX Series Wireless LAN Deployment Guide
71
to send overrides.
Phone Off Idle Timeout
This field represents the number of minutes that the device must be idle before
the device will request the power sourcing equipment (PSE) to power down the
device. The value in this field takes effect: - When the device was in Power Save
Plus mode as scheduled and was taken out of Power Save Plus mode because the
phone user pressed the select key - When the phone is repowered by the attached
switch - When the Phone Off Time is met but the phone is in use. The unit is
minutes. The default is 60. The range is 20 to 1440.
the device will request the power sourcing equipment (PSE) to power down the
device. The value in this field takes effect: - When the device was in Power Save
Plus mode as scheduled and was taken out of Power Save Plus mode because the
phone user pressed the select key - When the phone is repowered by the attached
switch - When the Phone Off Time is met but the phone is in use. The unit is
minutes. The default is 60. The range is 20 to 1440.
For more information on these features, see the Cisco DX Series Administration Guide or the Cisco DX Series Release Notes.
http://www.cisco.com/c/en/us/support/collaboration-endpoints/desktop-collaboration-experience-dx600-series/products-
maintenance-guides-list.html
maintenance-guides-list.html
http://www.cisco.com/c/en/us/support/collaboration-endpoints/desktop-collaboration-experience-dx600-series/products-release-
notes-list.html
notes-list.html
Configuring the Cisco Unified Wireless LAN Controller and Access
Points
Points
When configuring the Cisco Unified Wireless LAN Controller and Access Points, use the following guidelines:
• Ensure CCKM is Enabled if utilizing 802.1x authentication
• Set Quality of Service (QoS) to Platinum
• Set the WMM Policy to Required
• Ensure Session Timeout is enabled and configured correctly
• Ensure Aironet IE is Enabled
• Set DTPC Support to Enabled
• Disable P2P (Peer to Peer) Blocking Action / Public Secure Packet Forwarding (PSPF)
• Ensure Client Exclusion is configured correctly
• Disable DHCP Address Assignment Required
• Set MFP Client Protection to Optional or Disabled
• Set the DTIM Period to 2
• Set Client Load Balancing to Disabled
• Set Client Band Select to Disabled
• Set IGMP Snooping to Enabled
• Enable Symmetric Mobile Tunneling Mode if Layer 3 mobility is utilized
• Enable Short Preamble if using 2.4 GHz
• Enable ClientLink if utilizing Cisco 802.11n Access Points
• Configure the Data Rates as necessary
• Enable CCX Location Measurement
• Configure Auto RF as necessary
• Configure SIP CAC Support for Voice as necessary