Cisco Cisco 1900 2900 3900 Series 8-Port Gigabit Ethernet HS-WIC with PoE Information Guide

Page of 5
 
 
Q&A 
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 1 of 1 
Cisco Enhanced High-Speed WAN 
Interface Cards 
Cisco Gigabit Ethernet Dual-Identity Small Form-Factor Pluggable and Copper 
Enhanced High-Speed WAN Interface Card.  
Q.  What is a Cisco
®
 Enhanced High-Speed WAN Interface Card (EHWIC)? 
A.  The Cisco High-Speed WAN Interface Card (EHWIC) is an updated and enhanced version of the current 
HWIC for the Cisco Integrated Services Router Generation 2 (ISR G2). The EHWIC offers greater speeds (up 
to 800 Mbps bidirectionally) and higher port density than the current WIC. It also has a third row of pins for 
increased power to the cards, as well as support for Enhanced Power over Ethernet (EPoE) with up to 20 
watts per port. Furthermore, the EHWICs have a connection to the traditional router CPU and the new Multi-
Gigabit Fabric (MGF) backplane. EHWICs are available in single-wide and double-wide form factors. 
Q.  What is the EHWIC-1GE-SFP-CU? 
A.  The EHWIC-1GE-SFP-CU is a single-wide EHWIC with one Small Form-Factor Pluggable (SFP) slot. It has 
two ports: an SFP port and an RJ-45 copper connector port. Either the SFP or the RJ-45 can be active, but 
not both at the same time. For a list of SFPs supported, please refer to Table 1 later in this document.  
Q.  Which platforms are supported? 
A.  Cisco 1921, 1941, 1941W, 2900, 3900, and 3900E ISRs 
Q.  Is PoE supported? 
A.  No. 
Q.  Does the EHWIC-1GE-SFP-CU connect to the MGF? 
A.  No. This low-cost module connects only to the router’s CPU. 
Q.  Are there differences between the on-board Gigabit Ethernet ports and the EHWIC-1GE-SFP-CU? 
A.  The feature sets of the on-board Gigabit Ethernet ports and the EHWIC-1GE-SFP-CU are the same.  
Q.  What is the maximum throughput on the Gigabit Ethernet EHWIC? 
A.  The maximum theoretical throughput for the EHWIC-1GE-SFP-CU is 800 Mbps. Actual performance is based 
on the router’s CPU and is dependent on the router model. 
Q.  Is digital optical monitoring (DOM) supported? 
A.  Yes. The following DOM-related commands are supported: 
show int transceiver  
show int transceiver detail  
show int transceiver threshold table  
show int transceiver supported-list  
show int transceiver threshold violations  
show int <interface> transceiver  
show int <interface> transceiver detail