Cisco Cisco 2800 3800 Series 1-Port (SFP) Gigabit Ethernet High-Speed WIC Information Guide

Page of 4
 
 
Q&A 
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. 
Page 1 of 4 
Cisco Gigabit Ethernet High-Speed WAN Interface Card 
Overview 
Q.
 
What is a Cisco
®
 High-Speed WAN Interface Card (HWIC)? 
A.
 
The Cisco High-Speed WAN Interface Card (HWIC) is an updated and enhanced version of the current WIC for 
Cisco 2600 and 3700 series chassis. The HWIC offers greater speeds and higher port density than the current 
WIC. It also has a third row of pins for increased power to the cards, as well as support for both Power over 
Ethernet (PoE) and inline power based on Cisco Systems
®
 technology. HWICs are available in single-wide and 
double-wide form factors. 
Q.
 
What is the HWIC-1GE-SFP? 
A.
 
The HWIC-1GE-SFP is a single-wide HWIC with one Small Form-Factor Pluggable (SFP) slot. The SFP slot can 
be populated with Cisco copper and optical Gigabit Ethernet SFPs to provide 1-port Gigabit Ethernet 
connectivity on all Cisco Integrated Services Routers. The HWIC does not come with any default SFP; it must 
be ordered separately. For a list of SFPs supported, please refer to Table 1. 
Q.
 
Which platforms are supported? 
A.
 
Please refer to the module datasheet at 
http://www.cisco.com/en/US/prod/collateral/routers/ps5854/prod_qas0900aecd80169bf0.html
 
Q.
 
Is the HWIC-1GE-SFP supported on Cisco 1700, 2600, 3600, and 3700 series routers? 
A.
 
No. The HWIC-1GE-SFP is not supported on Cisco 1700, 2600, 3600, and 3700 series routers. The WIC slots 
on Cisco 1700, 2600, 3600, and 3700 cannot accommodate HWICs because the HWIC connector is different 
from that of a WIC.  
Q.
 
Are there differences between the on-board Gigabit Ethernet ports and the HWIC-1GE-SFP? 
A.
 
The feature set of the on-board Gigabit Ethernet ports and the HWIC-1GE-SFP is the same, except that Cisco 
EtherChannel
®
 is not supported on the on-board Gigabit Ethernet interfaces. 
Q.
 
Is the Gigabit Ethernet Network Module (NM-1GE) also supported in Cisco 2800 and 3800 series 
integrated service routers? 
A.
 
The NM-1GE is only supported on Cisco 3800 series routers. 
Q.
 
Is online insertion and removal (OIR) supported for modules in the HWIC slots? 
A.
 
No. OIR of modules in the HWIC slots is not supported. 
Q.
 
Which Cisco IOS
®
 Software Release and feature set is required? 
A.
 
Cisco IOS Software Release 12.3(8)T4 is required. 
Q.
 
What is the maximum throughput on the Gigabit Ethernet HWIC? 
A.
 
The HWIC bus interface is limited to 400 Mbps of full duplex. The actual throughput of the Gigabit Ethernet 
HWIC is limited by the throughput of individual platforms. Under bidirectional traffic of 1518 bytes or larger, the 
Gigabit Ethernet HWIC can support up to an aggregate of 350 Mbps on Cisco 2811 and 2821 routers, 400 Mbps 
on Cisco 2851 routers, and 500 Mbps on Cisco 3800 Series platforms. 
Q.
 
How many HWIC-1GE-SFPs are supported per chassis? 
A.
 
Please refer to the module datasheet at 
http://www.cisco.com/en/US/prod/collateral/routers/ps5854/prod_qas0900aecd80169bf0.html