Cisco Cisco Wireless LAN Controller Module Troubleshooting Guide
AutoInstall on Wireless LAN Controllers (WLCs)
with Microsoft DHCP Server Configuration
Example
with Microsoft DHCP Server Configuration
Example
Document ID: 111445
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
AutoInstall Feature on WLCs
Example
Configure the Microsoft DHCP server
Create a New Scope in the DHCP Server
Add the TFTP Option to the Scope
Add the Host Name Option to the Scope
Example of AutoInstall on Wireless Controllers
Troubleshoot
Related Information
Related Cisco Support Community Discussions
Prerequisites
Requirements
Components Used
Conventions
AutoInstall Feature on WLCs
Example
Configure the Microsoft DHCP server
Create a New Scope in the DHCP Server
Add the TFTP Option to the Scope
Add the Host Name Option to the Scope
Example of AutoInstall on Wireless Controllers
Troubleshoot
Related Information
Related Cisco Support Community Discussions
Introduction
This document describes how to use the AutoInstall feature on wireless LAN controllers.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basic knowledge of the configuration of lightweight APs and Cisco WLCs
•
Basic knowledge of Lightweight AP Protocol (LWAPP)
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco 4402 Series WLC that runs firmware 5.2.178.0
•
TFTP Server
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.