Cisco Cisco Wireless LAN Controller Module Technical Manual
Syslog Server Configuration on Wireless LAN
Controllers (WLCs)
Controllers (WLCs)
Document ID: 107252
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Prerequisites
Requirements
Components Used
Conventions
Syslog Server Support on Wireless LAN Controllers (WLCs)
Send Syslog Events to Multiple Servers
Verify
Troubleshoot
Related Information
Send Syslog Events to Multiple Servers
Verify
Troubleshoot
Related Information
Introduction
This document explains how to configure the Wireless LAN Controller for syslog servers.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Knowledge of how to configure the Wireless LAN Controller (WLC) and Lightweight Access Point
(LAP) for basic operation
(LAP) for basic operation
•
Basic knowledge of Lightweight Access Point Protocol (LWAPP)
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco 2000 / 2100 / 4400 Series WLC that runs firmware 5.0
•
LWAPP−based access points, Series 1230, 1240, 1130, 10x0, and 1500
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.