Cisco Cisco Wireless LAN Controller Module Leaflet
ACLs on Wireless LAN Controller Configuration
Example
Example
Document ID: 71978
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
ACLs on WLCs
Considerations When Configuring ACLs in WLCs
Configure ACL on WLCs
Configure Rules that Allow Guest User Services
Configure CPU ACLs
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
ACLs on WLCs
Considerations When Configuring ACLs in WLCs
Configure ACL on WLCs
Configure Rules that Allow Guest User Services
Configure CPU ACLs
Verify
Troubleshoot
Related Information
Introduction
This document explains how to configure access control lists (ACLs) on Wireless LAN Controllers (WLCs)
in order to filter traffic that enters and leaves a WLAN.
in order to filter traffic that enters and leaves a WLAN.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Knowledge of how to configure the WLC and Lightweight Access Point (LAP) for basic operation
•
Basic knowledge of Lightweight Access Point Protocol (LWAPP) and wireless security methods
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco 2000 Series WLC that runs firmware 4.0
•
Cisco 1000 Series LAP
•
Cisco 802.11a/b/g Wireless client adapter that runs firmware 2.6
•
Cisco Aironet Desktop Utility (ADU) version 2.6
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.