Cisco Cisco Wireless LAN Controller Module Technical Manual
Mesh and WGB Multiple VLAN Support
Configuration Example
Configuration Example
Document ID: 115752
Contributed by Surendra BG, Cisco TAC Engineer.
Feb 19, 2013
Feb 19, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for Mesh and Workgroup Bridge (WGB) multiple VLAN
support with open authentication (Open Auth) and with Lightweight Extensible Authentication Protocol
(LEAP).
support with open authentication (Open Auth) and with Lightweight Extensible Authentication Protocol
(LEAP).
Other Documents in this Series
Workgroup Bridges in a Cisco Unified Wireless Network Configuration Example
•
WGB Roaming: Internal Details and Configuration
•
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.