Cisco Cisco Prime Network Control System 1.0 Troubleshooting Guide
NCS Integration with ACS 5.4 Configuration
Example
Example
Document ID: 116358
Contributed by Minakshi Kumar, Cisco TAC Engineer.
Aug 23, 2013
Aug 23, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Add ACS as a TACACS Server
AAA Mode Settings
ACS Version 5.4 Configuration
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Add ACS as a TACACS Server
AAA Mode Settings
ACS Version 5.4 Configuration
Verify
Troubleshoot
Introduction
This document provides a configuration example for TACACS+ authentication and authorization on the Cisco
Prime Network Control System (NCS) Release 1.1.
Prime Network Control System (NCS) Release 1.1.
Prerequisites
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Define NCS as a client in the Access Control System (ACS).
•
Define the IP address and an identical shared−secret key on the ACS and NCS.
•
Components Used
The information in this document is based on these software and hardware versions:
ACS Version 5.4
•
NCS Prime Release 1.1
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.