Cisco Cisco Wireless Control System Version 4.0 Release Notes
15
Release Notes for Cisco Wireless Control System 6.0.132.0 for Windows or Linux
OL-19998-01
Caveats
antennas to focus transmissions in the direction of an 802.11a or 802.11g client, which increases the
downlink SNR and the data rate to the client, reduces coverage holes, and enhances overall system
performance. Client link works with all existing 802.11a and 802.11g clients.
downlink SNR and the data rate to the client, reduces coverage holes, and enhances overall system
performance. Client link works with all existing 802.11a and 802.11g clients.
Caveats
This section lists open and resolved caveats in Cisco WCS 6.0.132.0 for Windows and Linux.
Open Caveats
Caveats Associated with Release 6.0.132.0
These caveats are open in Cisco WCS 6.0.132.0 and are tied exclusively to that release:
•
CSCsj23423—The AP template is partially visible when switching between tasks and dates.
Workaround: Refresh the page or revisit the link.
•
CSCsv34264—An attempt to generate an ID certificate throws an SNMP Error.
Workaround: None.
•
CSCsv34781—The user is unable to synchronize WLC to the MSE after the WLC sysname changes.
Workaround: Before deleting the WLC from WCS, unsynchronize it from the MSE, then delete; or
change the sysname back to the original and then synchronize.
change the sysname back to the original and then synchronize.
•
CSCsw80427—A discovered H-REAP template displays the wrong PAC timeout value.
Workaround: Configure the H-REAP template from WCS instead.
•
CSCsx38955—After a database restore and upon synchronization, a controller can be assigned to
multiple MSEs that are running wIPS. No error message displays.
multiple MSEs that are running wIPS. No error message displays.
Workaround: Unassign controller wlc1 from one of the MSE and synchronize
•
CSCsx72413—When you enable the Diagnostic Channel for a WLAN and apply it to a device, audit
differences appear in the WLAN.
differences appear in the WLAN.
Workaround: After you apply the diagnostic channel changes to the device in WCS, run Refresh
Config from Controller.
Config from Controller.
•
CSCsx77870—Some configurations are missing from the Audit on Selected Parameters page.
Workaround: None.
•
CSCsy07751—When adding a new config group in WCS, the “Copy Templates from Controller”
feature does not function properly.
feature does not function properly.
Workaround: Do not use the Copy Templates from Controller feature. Discover the templates
separately and manually add them to the config group.
separately and manually add them to the config group.
•
CSCsy31176—When you successfully add a controller in WCS, the controller list page should
appear, but instead the add controller page reappears.
appear, but instead the add controller page reappears.
Workaround: Click Configure > Controllers to go to controller list page.
•
CSCsy31225—The Access Point Details page left navigation pane disappears when you click an
access point link from Configure > Controllers > <controller_ip> > Access Points > Cisco APs list
page.
access point link from Configure > Controllers > <controller_ip> > Access Points > Cisco APs list
page.