Cisco Cisco Prime Infrastructure 3.0 Release Notes

Click the identifier to view the impact and workaround for the caveat. This information is displayed in the

.

UDF values specific to device are not seen under wireless controllers.

Most recent cache (Alarm/Events/Syslog) and custom traps are not preserved in Secondary server after 
failover.

You cannot create a virtual domain in Operations Center using the results from Search.

Unable to expand location group in Virtual Domain page. 

Japanese characters are not allowed in Configuration Template Name field.

When you deselect 1,000 devices in the software image distribution page, the process can take up to two 
minutes and might hang. 

Data center device search is not working.

A wireless client authenticated on an SSID which has ISE authentication mapped to it moves to a 
non-ISE based SSID. (Say with WPA1 PSK). The client is shown as still authenticated against ISE. 

Unreachable AP count shows as 0 after failback in operational AP count dashboard.

Product Audit System (PAS) job is sometimes not created.

Secondary Health Monitor Event shows “failed to start Prime Infrastructure services.” 

When you delete a managed device that was discovered using APIC-EM Plug and Play, the device is 
re-added to the Prime Infrastructure inventory after approximately 2 hours.

PSIRT reports show data in non-root domains for devices in root domain.

Support Request Settings are not retained after upgrade.

Flexconnect AP Group template fails to deploy if the VLAN Support check box is disabled in wlan-vlan 
section for a 8.1.x.x wlc devices.

AP config save error appears when “Override vlan on AP” is enabled in flexconnect AP group.

Upgrade stage 4: “UtilSession failed” message is displayed.

After Failover to secondary, the Device Count and License Count are incorrect.

Importing an autonomous AP image from the AP3G1 family causes Prime Infrastructure’s Inventory > 
Software Images page to not display as expected.

Adding a device through SNMP v1 will get into collection failure in Prime Infrastructure 3.0.

Search for IPv6 clients based on IP addresses not working

Performance issues with Syslogs in Operations Center

filter criteria is reports is getting minimized

Unable to set Mobility Group Multicast with IPv4 address

Device selection refresh issue in IWAN Workflow