Cisco Cisco Content Switching Module Troubleshooting Guide
Configuration of the Content Switching Module on
a Catalyst 6000 Running CatOS System Software
a Catalyst 6000 Running CatOS System Software
Document ID: 41071
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Difference Between CatOS and Cisco IOS System Software
Background Information
Solution
Related Information
Prerequisites
Requirements
Components Used
Conventions
Difference Between CatOS and Cisco IOS System Software
Background Information
Solution
Related Information
Introduction
This document describes the important difference between a CatOS System Software and Cisco IOS
®
System
Software configuration of the Content Switching Module (CSM). All other CSM sample configurations are
configured with Cisco IOS Software on the Multilayer Switch Feature Card (MSFC), independent of the
CatOS or Cisco IOS Software choice.
configured with Cisco IOS Software on the Multilayer Switch Feature Card (MSFC), independent of the
CatOS or Cisco IOS Software choice.
Prerequisites
Requirements
Readers of this document should be knowledgeable of the following:
Configuration of trunking in CatOS.
•
Configuration of the MSFC running CatOS System Software.
•
Components Used
The information in this document is based on the software and hardware versions:
Catalyst 6500 running CatOS 7.5.1
•
MSFC running Cisco IOS 12.1(13)E4
•
CSM running 3.1.2
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.