Cisco Cisco 6015 IP DSL Switch Leaflet

To support the ADSL WIC on the Cisco 2600/3600, these hardware products are required:

2600: Chassis WIC slots, NM−2W

• 

3600: NM−1FE1R2W, NM−1FE2W, NM−2FE2W, NM−2W

• 

Note: For the Cisco 3600, ADSL is not supported on WIC NM−1E1R2W, NM−1E2W, or NM−2E2W.

To support the ADSL WIC, these are the minimum Cisco IOS Software releases required:

Cisco IOS Software Release 12.1(5)YB (Plus versions only) on the Cisco 2600/3600

• 

Cisco IOS Software Release IOS 12.1(3)XJ or later (Plus versions or ADSL feature set only) on the
Cisco 1700. The ADSL feature set is identified by "y7" in the image name; for example,
c1700−sy7−mz.121−3.XJ.bin.

• 

Note: When you download the image for the Cisco 1700, make sure you select the image name of 1700. Do
not download a 1720 or a 1750 image; the features does not support the ADSL WIC.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

For more information on document conventions, see the Cisco Technical Tips Conventions.

In this section, you are presented with the information to configure the features described in this document.

Note: To find additional information on the commands used in this document, use the Command Lookup
Tool (registered customers only) .

This document uses the network setup shown in the diagram below.

This document uses the configurations shown below.