SINGER SE340 LEGACY Instruction Manual

8

The presser foot must be changed according to the stitch 

RUWHFKQLTXH\RXVHZ,QIRUPDWLRQRQVHZLQJDQGVHZLQJ

WHFKQLTXHVEHJLQVRQSDJH

1. Turn the hand wheel toward you until the needle is at its

highest position.

2. Raise the presser foot lifter.

3. Remove the presser foot by pushing the presser foot

release lever toward you.

4. Place desired foot with its pin directly under the slot in

presser foot holder.

5. Lower the presser foot lifting lever and the presser foot will

snap into place.

When attaching presser feet that have their own shank, or 

when cleaning the machine, you should remove the presser 

foot holder.

1. Remove the presser foot.

2. Loosen the presser foot screw and remove the presser foot

holder.

3. To replace the holder, pull up the holder as far as it will go

from bottom of presser bar.

4. Tighten the presser foot screw securely using the

screwdriver.

NOTE:  This sewing machine is a low shank model.  When 

VKRSSLQJIRURSWLRQDO6,1*(5SUHVVHUIHHWDQGDFFHVVRULHV

make sure they are designed for low shank models.