Cisco Cisco Prisma II EDR Receiver Installation Guide
Appendix A
Module Parameter Descriptions
Module Parameter Descriptions
162
Parameter
Name (LCI)
Name (LCI)
ICIM
Abbreviation
Abbreviation
Description
Values
Default
Rx Mode
1
RxMode
1
Sets the receiver operating mode
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
0: 5GHz
1: 2.5GHz
1: 2.5GHz
5GHz
RF Ports
RxPorts
Sets whether the RF output is gated
to both connectors or just the top
connector. Refer to block diagrams
in page 36.
to both connectors or just the top
connector. Refer to block diagrams
in page 36.
1
2
2
1
Node Select
NodeSel
Selects the node to be monitored
(Node 1 to Node 4)
(Node 1 to Node 4)
1: Node 1
2: Node 2
3: Node 3
4: Node 4
2: Node 2
3: Node 3
4: Node 4
1
1
Parameter value can be modified by the user using the ICIM2 or ICIM2-XD, LCI software,
ROSA software, CLI commands, or the ICIM Web Interface.