Cisco Cisco Prisma II EDR Receiver Installation Guide
Chapter 2 Module Installation
46
Preparing for Installation
Before you begin, make sure that the module is in good condition and that you have
the tools and equipment listed here.
the tools and equipment listed here.
Unpacking and Inspecting the Module
As you unpack the module, inspect it for shipping damage. If you find any damage,
contact Cisco Services. Refer to Customer Information (on page 137) for contact
information.
contact Cisco Services. Refer to Customer Information (on page 137) for contact
information.
Equipment and Tools Needed
Before you begin, make sure that the module is in good condition. You need the
following equipment and tools to install these modules.
following equipment and tools to install these modules.
You need . . .
To . . .
a Prisma II or Prisma II XD Chassis with
power supply
power supply
provide housing, power, and input/output
connections to the module.
connections to the module.
3/8-in. flat-blade screwdriver
secure the module in the chassis.
optical cables with connectors
carry optical input and output signals.
optical cleaning materials
clean optical connectors.
optical power meter
verify optical input and output levels.
spectrum analyzer (for transmitter)
verify proper RF input.