Cisco Headend System Release 2.7 Release Notes

Page of 198
 
 
Configuring Secondary BFS QAMs on an SDV System (Optional) 
4019475 Rev D 
97 
 
Session Number 
Program Number 
14 
134 
16 
135 
18 
136 
20 
137 
22 
138 
24 
139 
26 
140 
28 
141 
30 
142 
32 
143 
199 
144 
4  Once the PAT Configuration Table has been modified, update any secondary 
BFS QAMs by tearing down any session greater than 22 and rebuilding the 
session with the correct Program Number. 
 
Adding BFS Sources - Sites Using Direct ASI 
Complete the following procedure if your DNCS uses the Direct ASI option to 
distribute BFS data. 
Note: A benefit of using the Direct ASI option is that you only need to build sessions 
as you need them on your primary and secondary BFS QAMs. There is no need to tear 
down any DNCS sessions greater than 22 as you would do within a BFS QAM 
system. 
1  As BFS sources are built, the DNCS automatically retrieves the next available 
program number from the source list. As a result, there is no need to update the 
PAT Configuration Table by hand. 
In the following example, note that Session 22 is Program Number 138, while 
Session 199 is Program Number 139, and Session 24 is Program Number 140. 
When Session 24 was built, it took the next available Program Number, which 
was 140. With the Direct ASI model, you can have Program Numbers out of 
sequence in the PAT Configuration table. 
Example:  
Session Number 
Program Number 
128 
129 
130 
131