Cisco Headend System Release 2.7 Release Notes

Appendix C

Direct ASI Installation and Configuration Procedures

152

4019475 Rev D

Set Up the QAM

After creating the MPEG source, follow these instructions to set up the QAM.
1 From the DNCS Administrative Console, click Element Provisioning and then

select QAM. The QAM List window opens.

2 Double-click the BFS QAM. The Set Up QAM window opens.

3 On the Set Up QAM window, configure the Input Port field to ASI.
4 Configure the INPUT Transport Stream ID field with the same value that you

recorded as the TSID on the Set Up MPEG Source window in a previous
procedure, Creating an MPEG Source (on page 149).

5 Click the Connectivity tab.