Cisco Headend System Release 2.7 Release Notes
Chapter 2 DNCS Pre-Upgrade Procedures
42
4019475 Rev D
Verify that Boot Device is Correctly Configured
Before upgrading the DNCS, use the following procedure to verify that the boot
device is properly configured.
1 If necessary, open an xterm window on the DNCS.
2 Type eeprom boot-device and then press Enter.
3 Did you see disk:a listed as the boot device?
device is properly configured.
1 If necessary, open an xterm window on the DNCS.
2 Type eeprom boot-device and then press Enter.
3 Did you see disk:a listed as the boot device?
If yes, then you have completed this procedure.
If no, type eeprom boot-device=disk:a and then press Enter to reset the
default boot device to the original disk.
default boot device to the original disk.