Cisco Headend System Release 2.7 Installation Guide
Reconfigure the QAM
4023737 Rev C
155
Reconfigure the QAM
Follow these instructions to reconfigure the BFS QAM to support the rollback of
Direct ASI.
1 From the DNCS Administrative Console, click the Element Provisioning tab and
Direct ASI.
1 From the DNCS Administrative Console, click the Element Provisioning tab and
then select QAM. The QAM List window opens.
2 Double-click the entry for the BFS QAM. The Set Up QAM window opens.
3 Select the Connectivity tab.
4 In the Connect To area of the window, click the arrow to the right of each of the
3 Select the Connectivity tab.
4 In the Connect To area of the window, click the arrow to the right of each of the
following fields and set each field to none:
Device Type
Device Name
Card Type
Slot Number
Port Number
5 Click Save.
6 Select the Basic Parameters tab on the Set Up QAM window.
7 In the Input Port field, select SWIF.
6 Select the Basic Parameters tab on the Set Up QAM window.
7 In the Input Port field, select SWIF.
Exception: If your system uses ASI output from the Msync card, leave the Input
Port field at ASI.
Port field at ASI.
8 In the Input Transport Stream ID field, enter the value from the SWIF transmit
card on the BIG.
Note: You can find this value by clicking Show TSIDs from the Connectivity tab
of the Set Up BIG window.
Note: You can find this value by clicking Show TSIDs from the Connectivity tab
of the Set Up BIG window.
9 Click Save.
10 Select the Connectivity tab again on the Set Up QAM window.
10 Select the Connectivity tab again on the Set Up QAM window.