Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 2 SR 5.0 Pre-Upgrade Procedures
22
4042225 Rev B
Check the Number of BFS Sessions
The number of BFS sessions post-upgrade needs to equal the number of pre-upgrade
sessions. Use this procedure to determine and record the number of pre-upgrade
BFS sessions. Then, after the upgrade, you will determine the number of
post-upgrade BFS sessions.
Follow this procedure to check and record the number of pre-upgrade BFS sessions.
1 Press the Options button on the front panel of the BFS QAM until the Session
sessions. Use this procedure to determine and record the number of pre-upgrade
BFS sessions. Then, after the upgrade, you will determine the number of
post-upgrade BFS sessions.
Follow this procedure to check and record the number of pre-upgrade BFS sessions.
1 Press the Options button on the front panel of the BFS QAM until the Session
Count total appears.
2
Record the Session Count total in the space provided. __________
3 Does the system you are upgrading use the ASI card?
If yes, from the dncs xterm window, type the following command and press
Enter.
Enter.
/opt/solHmux64/vpStatus -d /dev/Hmux0 -P 0
Example: Output from the command should look similar to the following:
If no, is your system currently running SR 5.0 AND are your BFS sessions
Multicast?
– If yes, go to step 4.
– If no (to either condition), go to the next procedure in this chapter.
Multicast?
– If yes, go to step 4.
– If no (to either condition), go to the next procedure in this chapter.