Cisco Cisco Broadband Access Center Telco Wireless 3.7
C-17
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
System Commands
Examples
This is an example of how to use the show ip route command:
show ip
Usage Guidelines
This command shows the DPEs current general IP settings. For specific interface settings, use the show
interface commands. These are the settings used when the DPE is rebooted.
interface commands. These are the settings used when the DPE is rebooted.
Examples
This is an example of how to use the show ip command:
dpe# show ip
hostname = BPR_host
domainname = cisco.com
gateway = 10.10.20.10
show memory
Usage Guidelines
This command identifies how much current memory and swap space the DPE is using.
Examples
This is an example of how to use the show memory command:
dpe# show memory
show running-config
Usage Guidelines
This command displays the current configuration of the DPE.
All of the configuration options are displayed using the actual commands to set the options. If you copy
this output, you can paste it back into the configurations for other DPEs modifications. In this way, you
can quickly create the configurations for multiple devices needing identical configurations.
this output, you can paste it back into the configurations for other DPEs modifications. In this way, you
can quickly create the configurations for multiple devices needing identical configurations.
Note
The values that are displayed by this command are dependent on whether a Telnet session or console
connection is used.
connection is used.
dpe# show ip route
Destination
Gateway
Genmask
Flags
Metric
Ref
Use
Iface
10.10.10.5
10.10.20.10
255.255.255.0
U
O
O
O
eth0
10.10.10.6
10.10.20.25
255.255.255.125
U
O
O
O
lo
10.10.10.9
10.10.20.50
255.255.255.255
UG
0
0
0
eth0
Mem:
Swap:
255112K av,
265032K av,
148928K used
0K used
106184K free
265032 free
OK shrd
5428K buff
72468K cached