Cisco Cisco Aironet 1140 Access Point Installation Guide

This product relies on the building’s installation for short-circuit (overcurrent) 
protection. Ensure that the protective device is rated not greater than: 
20A. Statement 1005

Do not operate your wireless network device near unshielded blasting caps or in an 
explosive environment unless the device has been modified to be especially qualified for 
such use. Statement 245B

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be 
located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. 
Statement 332

When mounting the access point to a wall or ceiling, be sure to use appropriate fasteners. 
The fasteners used must be capable of maintaining a minimum pullout force of 20 lbs (9 
kg) and must use all 4 indented holes on the low-profile mounting bracket.

This product and all interconnected equipment must be installed indoors within the same 
building, including the associated LAN connections as defined by Environment A of the 
IEEE 802.af Standard.

The access point is suitable for use in environmental air space in accordance with section 
300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the 
Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power 
injector in air handling spaces.

Use only with listed ITE equipment.