Cisco Cisco TelePresence MCU 4510 Maintenance Manual
Configuring network settings
Cisco TelePresence MCU Version 4.2 Printable online help
Page 182 of 252
IPv6 configuration
IP
configuration
configuration
Specifies whether the port should be
configured manually or automatically, or
disabled. If set to Automatic via
SLAAC/DHCPv6 the MCU obtains its own
IP address for this port automatically. The
protocol used will be SLAAC, Stateful
DHCPv6, or Stateless DHCPv6 as
indicated by the ICMPv6 Router
Advertisement (RA) messages. If set to
Manual the MCU will use the values that
you specify in the Manual configuration
fields below.
configured manually or automatically, or
disabled. If set to Automatic via
SLAAC/DHCPv6 the MCU obtains its own
IP address for this port automatically. The
protocol used will be SLAAC, Stateful
DHCPv6, or Stateless DHCPv6 as
indicated by the ICMPv6 Router
Advertisement (RA) messages. If set to
Manual the MCU will use the values that
you specify in the Manual configuration
fields below.
Manual configuration
IPv6 address
The (hexadecimal) colon-separated IPv6
address for this port, for example
[2001:db8::].
address for this port, for example
[2001:db8::].
See
for more information about IPv6 addresses
that are assigned automatically.
that are assigned automatically.
You only need to specify this option if you
have chosen Manual IP configuration, as
described above.
have chosen Manual IP configuration, as
described above.
If IP configuration is set to Automatic via
SLAAC/DHCPv6 this setting is ignored.
SLAAC/DHCPv6 this setting is ignored.
When you enter an IPv6 address
anywhere in the user interface, the
address must be enclosed in square
brackets [ ].
anywhere in the user interface, the
address must be enclosed in square
brackets [ ].
Prefix length
The (decimal) prefix length value for the
global IPv6 address for this port. In the
above IPv6 address example, the prefix
length is 32.
global IPv6 address for this port. In the
above IPv6 address example, the prefix
length is 32.
Default
gateway
gateway
Optionally, specifies the IPv6 address of
the default gateway on this subnet.
the default gateway on this subnet.
The address can be global or link-local.
IP status
Use the IP status fields to verify the current IP settings for the appropriate Ethernet port of the MCU,
which were obtained using DHCP/SLAAC or configured manually (see
which were obtained using DHCP/SLAAC or configured manually (see
including:
DHCP
IP address
Subnet mask
Default gateway
DHCPv6
IPv6 address
IPv6 default gateway
IPv6 link-local address