Cisco Cisco TelePresence MCU 4510 Maintenance Manual
Configuring SNMP settings
Cisco TelePresence MCU Version 4.2 Printable online help
Page 196 of 252
Trap receiver
addresses 1 to
4
addresses 1 to
4
Enter the IP address or hostname for up to
four devices that will receive both the
general and the authentication failure
traps.
four devices that will receive both the
general and the authentication failure
traps.
The traps that are sent by the MCU for
IPv4 are SNMP v1 traps. For IPv6 the
MCU sends SNMP v2 traps. You can
configure trap receivers or you can view
the MIB using a MIB browser. You can set
the UDP port number for the trap in the
format <IP address>: <port number>. By
default the UDP port number is 162. Note
that square brackets are mandatory for
IPv6 addresses.
IPv4 are SNMP v1 traps. For IPv6 the
MCU sends SNMP v2 traps. You can
configure trap receivers or you can view
the MIB using a MIB browser. You can set
the UDP port number for the trap in the
format <IP address>: <port number>. By
default the UDP port number is 162. Note
that square brackets are mandatory for
IPv6 addresses.
Access control
Field
Field description
Usage tips
RO
community
community
Community string/password that gives
read-only access to all trap information.
read-only access to all trap information.
Note that SNMP community strings are not
secure. They are sent in plain text across
the network.
secure. They are sent in plain text across
the network.
It is advisable to change the community
strings before enabling SNMP as the
defaults are well known.
strings before enabling SNMP as the
defaults are well known.
RW
community
community
Community string/password that gives
read/write access to all trap information.
read/write access to all trap information.
Trap
community
community
Community string/password that is sent
with all traps.
with all traps.
Some trap receivers can filter on trap
community.
community.