Cisco Cisco Web Security Appliance S380 Release Notes

Page of 76
I R O N P O R T   A S Y N C O S   6 . 3 . 7   F O R   W E B   R E L E A S E   N O T E S
 
31
Fixed: McAfee scanning engine stops working after a feature key is updated in some 
cases resulting in latency
Previously, the McAfee scanning engine stopped scanning transactions when the McAfee 
feature key expired and then was updated. This resulted in slow response times for 
transactions. This no longer occurs. Now, McAfee scanning works after the feature key is 
updated after expiration and no latency is observed. [Defect ID: 50591] 
Fixed: Web Proxy stops processing transactions after upgrading from a version with an 
invalid configuration in some cases
Previously, the Web Proxy stopped processing transactions and the proxy logs showed error 
messages saying, “Couldn’t determine available system storage.” This happened after 
upgrading from a previous version that had a custom URL category that was deleted, but the 
configuration file still had some residual references to the deleted custom URL category. This 
no longer occurs. [Defect ID: 50839] 
Fixed: Web Proxy does not start when it fails nslookups on its own IP address
Previously, the Web Proxy did not start when it failed nslookups on its own IP address. This no 
longer occurs. [Defect ID: 50853] 
Fixed: Web Proxy generates a core file when processing very long URIs in some cases
Previously, the Web Proxy generated a core file when processing very long URIs after an 
internal failure. This no longer occurs. [Defect ID: 50986] 
Fixed: Wrong action taken on upload requests with IronPort Data Security Policies and 
custom URL categories in some cases
Previously, when an upload request was matched to an IronPort Data Security Policy, and the 
URL in the request matched a custom URL category set to Monitor, the Web Proxy applied the 
action defined for the applicable predefined URL category instead. This no longer occurs. 
[Defect ID: 51027] 
Fixed: HTTP requests fail when the request header is slightly smaller than 16K in size
Previously, HTTP requests failed when the request header was slightly smaller than 16K in 
size. This no longer occurs. [Defect ID: 51083] 
Fixed: CPU utilization rate is very high with a large number of policies
Previously, the CPU utilization rate was very high with a large number of policies. This no 
longer occurs. [Defect ID: 51362] 
Fixed: Application fault occurs in the CLI when creating a new Request Debug log
Previously, an application fault occurred in the CLI when creating a new Request Debug log 
using the 
logconfig
 CLI command. This no longer occurs. [Defect ID: 51406]