Cisco Cisco Web Security Appliance S690 User Guide

You can configure SNMP traps (enable or disable specific traps) when you enable 
SNMP for an interface. To specify multiple trap targets: when prompted for the 
trap target, you may enter up to 10 comma separated IP addresses.

In the following example, the 

snmpconfig

 command is used to enable SNMP on 

the “PublicNet” interface on port 161. A passphrase for version 3 is entered and 
then re-entered for confirmation. The system is configured to service version 1 
and 2 requests, and the community string 

public

 is entered for GET requests from 

those versions 1 and 2. The trap target of 

10.1.1.29

 is entered. Finally, system 

location and contact information is entered.

example.com> snmpconfig

Current SNMP settings:

SNMP Disabled.

Choose the operation you want to perform:

- SETUP - Configure SNMP.

[]> setup

Do you want to enable SNMP? [N]> y

Please choose an IP interface for SNMP requests.

1. Management (192.168.1.1/24: wsa01-vmw1-tpub.qa)

[1]>

Enter the SNMPv3 passphrase.