Cisco Cisco Web Security Appliance S160 User Guide

Connect the Appliance to networks and devices. 

Complete the System Setup Wizard worksheet.

.

If you are setting up a virtual appliance: 

Use the 

loadlicense

 command to load the virtual appliance license. For complete information, 

see the Cisco Content Security Virtual Appliance Installation Guide, available from 

. 

Enable the HTTP and/or HTTPS interfaces: In the command-line interface (CLI), run the 

interfaceconfig

 command. 

Note that reference information for each configuration item used in the System Setup Wizard is 
available at 

.

Open a browser and enter the IP address of the Web Security appliance. The first time you run the System 
Setup Wizard, use the default IP address:

https://192.168.42.42:8443

 

-or-

http://192.168.42.42:8080

 

where 

192.168.42.42 

is the default IP address, and

 8080 

is the default admin port setting for HTTP, 

and 

8443

 is default admin port for HTTPS.

Otherwise, if the appliance is currently configured, use the IP address of the M1 port.

When the appliance login screen appears, enter the username and passphrase to access the appliance. By 
default, the appliance ships with the following username and passphrase:

Username: 

IPv4 Address (required)

IPv6 Address (optional)

Administrator Passphrase

Network Mask

Email System Alerts To

Hostname

(Optional) SMTP Relay Host

IPv4 (optional)

IPv6 Address (optional)

Network Mask

Hostname