Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Installation Guide
6
Connecting the Cisco SM-X-PVDM Module
Safety Warnings
Figure 4
Removing the Module from the Router (router model shown: Cisco ISR 4451-X)
5.
Pull the Cisco SM-X-PVDM out of the chassis.
6.
Place the module in an antistatic bag to protect it from electrostatic discharge (ESD) damage.
7.
Replace the blank faceplate for the chassis slot that held the module.
Note: Do not operate the system without the faceplate in place. The faceplate is an integral part of the chassis,
helping to: (a) prevent exposure to hazardous voltages and currents inside the chassis; (b) contain electromagnetic
interference (EMI) that might disrupt other equipment; and (c) direct the flow of cooling air through the chassis.
helping to: (a) prevent exposure to hazardous voltages and currents inside the chassis; (b) contain electromagnetic
interference (EMI) that might disrupt other equipment; and (c) direct the flow of cooling air through the chassis.
Safety Warnings
Warning:
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning:
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The telecommunications
lines must be disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both.
Statement 1043
lines must be disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both.
Statement 1043
Warning:
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Statement 1
Warning:
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning:
Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF or
ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables, detach the end
away from the unit first. Statement 1026
away from the unit first. Statement 1026
Warning:
Before opening the unit, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. Statement 1041
Warning:
Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious
burns or weld the metal object to the terminals. Statement 43
burns or weld the metal object to the terminals. Statement 43
1
Mounting screws on the module faceplate
2
1
3
64596
EN
L
L
1