Cisco Cisco Catalyst 4000 Supervisor Engine II Installation Guide

Corporate Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Installing Gigabit Ethernet Boards in Cisco
Ethernet Switch Network Modules

Product Numbers: GE-DCARD-ESW

This document describes how to install the optional Gigabit Ethernet board in the Ethernet switch
network module.

Network module installation documents provide detailed instructions for network module installation
and cabling. You can access these documents at: Cisco Product Documentation > Access Servers and
Access Routers > Modular Access Routers > Cisco platform you are using> Hardware installation
documents for Cisco platform you are using > Network module (netmod) installation

This document contains the following sections:

•

Safety Information, page 1

•

Tools and Equipment Needed, page 2

•

Adding an Optional Gigabit Ethernet Expansion Board, page 2

•

Obtaining Documentation, page 4

•

Obtaining Technical Assistance, page 5

Safety Information

For safety information you need to know before working on your Cisco router, see the Regulatory
Compliance and Safety Information document that accompanied this device.

Warning

Only trained and qualified personnel should be allowed to install or replace this equipment. To see
translations of the warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.

Caution

Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. Always follow ESD
prevention procedures when removing and replacing cards.