Cisco Cisco 1900 2900 3900 Series 8-Port Gigabit Ethernet HS-WIC with PoE
Configuring the HWIC-1VDSL
Prerequisites for the HWIC-1VDSL
2
Configuring the HWIC-1VDSL
OL-22205-01
Prerequisites for the HWIC-1VDSL
This section lists the prerequisites for configuring the HWIC-1VDSL.
•
Ensure that you have the appropriate Cisco access router to serve as the host router. The following
Cisco access routers support HWIC-1VDSL.
Cisco access routers support HWIC-1VDSL.
–
Cisco 1900 series ISRs
–
Cisco 2900 series ISRs
–
Cisco 3900 series ISRs
•
Use the show version command to ensure that the router is running
Cisco IOS Release 15.0(1)M1
or later.
Note
When minimum release requirements are met, you can change images on the router without
affecting performance.
affecting performance.
•
Install the HWIC-1VDSL on the router, using the directions provided in
.
Restrictions for the HWIC-1VDSL
Online insertion and removal is not supported for HWIC-1VDSL.
Overview of the HWIC-1VDSL
The HWIC-1VDSL is used on the Cisco ISR G2 platforms to provide VDSL over POTs WAN
connectivity. It can be installed on Cisco ISR G2 platforms, and the external RJ-11 port is connected to
a DSL line coming from VDSL2 supported DSLAM.
connectivity. It can be installed on Cisco ISR G2 platforms, and the external RJ-11 port is connected to
a DSL line coming from VDSL2 supported DSLAM.
To configure the HWIC-1VDSL, you should understand the following concepts:
•
VDSL2
•
Ethernet over VDSL (PTM) mode