Cisco Cisco Catalyst 6000 Multilayer Switch Feature Card MSFC2 Installation Guide
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Connecting Cisco Intrusion Detection System
Network Modules to the Network
Network Modules to the Network
Revised: May 1, 2008, OL-12826-01
This guide describes how to connect Cisco Intrusion Detection System (IDS) network modules to your
network. It contains the following sections:
network. It contains the following sections:
•
•
•
•
•
Cisco IDS Network Modules
This section provides information on the Cisco IDS network module (NM-CIDS-K9) (see
Caution
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the Cisco IDS network module (NM-CIDS-K9) only to intrabuilding or nonexposed wiring or
cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.
connect the Cisco IDS network module (NM-CIDS-K9) only to intrabuilding or nonexposed wiring or
cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Figure 1
Faceplate for the NM-CIDS-K9 Network Module
95059
NM-CIDS-K9
EN
PWR
FastEthernet 0
DISK
LINK
ACT
Command & Control
CF