Cisco Cisco Catalyst 4000 Supervisor Engine II Installation Guide
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Connecting Cisco Unity Express Network
Modules to the Network
Modules to the Network
Revised: May 1, 2008, OL-12827-01
This guide describes how to connect Cisco Unity Express network modules to your network. It contains
the following sections:
the following sections:
•
•
•
•
Cisco Unity Express Network Module Overview
This section provides information on the Cisco Unity Express network module (NM-CUE). (See
.)
Caution
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the Cisco Unity Express network module (NM-CUE) only to intrabuilding or nonexposed wiring
or cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.
connect the Cisco Unity Express network module (NM-CUE) only to intrabuilding or nonexposed wiring
or cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends.
Note
The Fast Ethernet port and CompactFlash slot, though available on the hardware, are not supported by
the Cisco Unity Express network module. The compact Flash slot has a metal cover.
the Cisco Unity Express network module. The compact Flash slot has a metal cover.