Cisco Cisco Unified SIP Proxy Technical Manual
CUSP Configuration Example
Document ID: 116252
Contributed by Ajeet Singh, Cisco TAC Engineer.
Aug 06, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Scenario 1
Scenario 2
Scenario 3
Scenario 4
Configuration for All Four Scenarios
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Configure
Scenario 1
Scenario 2
Scenario 3
Scenario 4
Configuration for All Four Scenarios
Verify
Troubleshoot
Related Information
Introduction
This document describes the sample CLI and GUI configuration of Cisco Unified SIP Proxy (CUSP) with
debugs that match four different call routing scenarios.
debugs that match four different call routing scenarios.
Prerequisites
Requirements
Cisco recommends that you have basic knowledge of these topics:
Session Initiation Protocol (SIP)
•
Cisco Unified SIP Proxy (CUSP)
•
Components Used
The information in this document is based on CUSP.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Configure
This section describes the configuration of four call routing scenarios.