Cisco Cisco 3G Wireless WAN (GPRS EDGE UMTS HSDPA HSUPA) Interface Card
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco/Verizon Public Information.
Page 6 of 20
NEMO Router Configuration for ISR G2 - EHWIC-4G-LTE-V, EHWIC-4G-LTE-VZ
!### command allowing for “LTE test cellular” enable mode commands ###
service internal
!
!### Load appropriate IOS image ###
!### Load appropriate IOS image ###
boot system flash: c1900-universalk9-mz.SPA.155-2.T.bin
!
ip cef
!
!### CHAT Script to make a data call, name is case-sensitive ###
ip cef
!
!### CHAT Script to make a data call, name is case-sensitive ###
chat-script LTE "" AT!CALL1” TIMEOUT 20 “OK”
!
!### T1 Controller for Primary Circuit ###
!### T1 Controller for Primary Circuit ###
controller T1 0/1/0
channel-group 0 timeslots 1-24
!
!### This Loopback and IP are required to setup NEMO. This address is not
routable and is used as a placeholder “dummy” address. It may be the same on
all routers. Any interface number and any IP can be used. Please use 1.2.3.4
for consistency if possible. ###
!
!### This Loopback and IP are required to setup NEMO. This address is not
routable and is used as a placeholder “dummy” address. It may be the same on
all routers. Any interface number and any IP can be used. Please use 1.2.3.4
for consistency if possible. ###
!
interface Loopback1234
description ### NEMO Router Home Address – Dummy non-Routable IP ###
ip address 1.2.3.4 255.255.255.255
ip address 1.2.3.4 255.255.255.255
!
!### This Subnet will be routed by NEMO ###
interface Loopback255
!### This Subnet will be routed by NEMO ###
interface Loopback255
ip address 10.0.255.1 255.255.255.255
!
!### This subnet is routed by NEMO. The maximum TCP MSS is set to 1390
bytes. The route-map clears DF bits in the IP headers. ###
!
interface GigabitEthernet0/0
!### This subnet is routed by NEMO. The maximum TCP MSS is set to 1390
bytes. The route-map clears DF bits in the IP headers. ###
!
interface GigabitEthernet0/0
ip address 10.20.59.129 255.255.255.128
ip tcp adjust-mss 1390
ip policy route-map clear-df
ip policy route-map clear-df
!### This subnet is not routed by NEMO and will not be backed up. ###
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/1
ip address 10.10.20.233 255.255.255.0
!
!### Interface Cellular – the LTE and NEMO interface. Receives Pool/WAN IP
(dynamic or static) from EXGW. The backup is activated using the Dialer
Watch group. See the Dialer Watch section for the backup timers. By default
the “dialer idle-timeout” is set to 120 sec. The value of this timer should
not exceed 9 min. This timer and the “dialer watch-group 1 delay disconnect”
timer are used to set the time period to disconnect LTE after the primary
circuit becomes operational. ###
!
!### Interface Cellular – the LTE and NEMO interface. Receives Pool/WAN IP
(dynamic or static) from EXGW. The backup is activated using the Dialer
Watch group. See the Dialer Watch section for the backup timers. By default
the “dialer idle-timeout” is set to 120 sec. The value of this timer should
not exceed 9 min. This timer and the “dialer watch-group 1 delay disconnect”
timer are used to set the time period to disconnect LTE after the primary
circuit becomes operational. ###
!
interface Cellular0/0/0
ip address negotiated
no ip unreachables
ip mobile router-service roam
no ip unreachables
ip mobile router-service roam