Cisco Cisco 4G LTE Enhanced High-Speed WAN Interface Cards for LATAM Information Guide
Q&A
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 12 of 19
using OTASP activation one more time.
Q.
A.
A.
Q.
A.
Q.
A.
Q.
A.
What is DMU?
Dynamic Mobile IP Key Update is a technique Verizon Wireless uses to distribute keys to a
mobile device the first time it is activated. DMU is described in RFC 4784.
Dynamic Mobile IP Key Update is a technique Verizon Wireless uses to distribute keys to a
mobile device the first time it is activated. DMU is described in RFC 4784.
My customer wants to know how to definitively determine which service is being used,
EVDO or 1xRTT, when the call is active.
After a data connection is set up, you can verify from looking at the output of the show cellular
connection command. The current call state would tell if it is a 1xRTT or EVDO (HDR) call.
After a data connection is set up, you can verify from looking at the output of the show cellular
connection command. The current call state would tell if it is a 1xRTT or EVDO (HDR) call.
Router#show cellular 0/0/0 connection
Phone number of outgoing call = #777
HDR AT State = Connected, HDR Session State = Open
HDR Session Info:
UATI (Hex) = 0080:0580:0000:0001:080A:CCC5:45C2:3B47
Color Code = 237, RATI = 0xB29DCCDD
Session duration = 624 msecs, Session start = 2624229538 msecs
Session end = 2624230592 msecs, Authentication Status =
Authentication disabled
Authentication disabled
HDR DRC Value = 2, DRC Cover = 0, RRI = 9.6 kbps
Current Transmitted = 11202 bytes, Received = 10203 bytes
Total Transmitted = 28801 KB, Received = 28192 KB
Current Call Status = CONNECTED Privacy Mode = OFF, Service Option =
33023
33023
Current Call Duration = 1288 secs
Total Call Duration = 3216600 seconds
Current Call State = AT Packet Call
Last Call Disconnect Reason = Base station release (No reason)
Last Connection Error = None
HDR DDTM (Data Dedicated Transmission Mode) Preference = Off
Mobile IP Error Code (RFC-2002) = 0 (Registration accepted)
Router#
My laptop is running an EVDO Rev A connection card with a signal of -92 dBm. Why
would the signal be so much worse with the 3G HWIC WWAN card: it is -125 dBm?
This reading (-125 dBm) means there is no signal, so the modem is not seeing the EVDO
service. Verify with the show cellular all command that the modem can see the EVDO signal.
Also verify that an antenna is connected to the main antenna input of the 3G HWIC.
This reading (-125 dBm) means there is no signal, so the modem is not seeing the EVDO
service. Verify with the show cellular all command that the modem can see the EVDO signal.
Also verify that an antenna is connected to the main antenna input of the 3G HWIC.
What is the difference between the following two commands?
cellular 0/1/0 gsm band gsm-all-bands
cellular 0/1/0 gsm band auto-band
The gsm-all-bands command connects only to a 2G service (no wideband CDMA [WCDMA]).
The auto-band command is the default setting in the modem; with this configuration the
modem connects to 3G service if available.
modem connects to 3G service if available.