Cisco Cisco SM-X Layer 2 3 EtherSwitch Service Module

Before you can access the modules, you must connect to the host router through the router console or 
through Telnet. Once you are connected to the router, ope a session to your module using the hw-module 
session command in privileged EXEC mode. 

You can use the following method to establish a connection to the module:

Connect to the router console using Telnet or Secure Shell (SSH) and open a session to the switch using 
the hw-module session slot/subslot command in privileged EXEC mode on the router.

You can use the following configuration examples to establish a connection:

Open a session from the router using the following command:

Router# hw-module session 1/0

Establishing session connect to subslot 1/0

To exit, type ^a^q

picocom v1.4

port is        : /dev/ttyDASH0

flowcontrol    : none

baudrate is    : 9600

parity is      : none

databits are   : 8

escape is      : C-a

noinit is      : no

noreset is     : no

nolock is      : yes

send_cmd is    : ascii_xfr -s -v -l10

receive_cmd is : rz -vv

Terminal ready

Switch#