Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP Technical References
2-148
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide
380265-002
Chapter 2 CGESM Switch Cisco IOS Commands
mac access-list extended
mac access-list extended
Use the mac access-list extended global configuration command to create an access list based on MAC
addresses for non-IP traffic. Using this command puts you in the extended MAC access-list
configuration mode. Use the no form of this command to return to the default setting.
addresses for non-IP traffic. Using this command puts you in the extended MAC access-list
configuration mode. Use the no form of this command to return to the default setting.
mac access-list extended name
no mac access-list extended name
Syntax Description
Defaults
By default, there are no MAC access lists created.
Command Modes
Global configuration
Command History
Usage Guidelines
MAC named extended lists are used with VLAN maps and class maps.
You can apply named MAC extended ACLs to VLAN maps or to Layer 2 interfaces.
Entering the mac access-list extended command enables the MAC access-list configuration mode.
These configuration commands are available:
These configuration commands are available:
•
default: sets a command to its default.
•
deny: specifies packets to reject. For more information, see the
MAC access-list configuration command.
•
exit: exits from MAC access-list configuration mode.
•
no: negates a command or sets its defaults.
•
permit: specifies packets to forward. For more information, see the
command.
For more information about MAC extended access lists, see the Cisco Gigabit Ethernet Switch Module
for HP p-Class BladeSystem Software Configuration Guide for this release.
for HP p-Class BladeSystem Software Configuration Guide for this release.
name
Assign a name to the MAC extended access list.
Release
Modification
12.2(25)SE1
This command was introduced.