Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP Technical References
B-52
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide
380265-002
Appendix B CGESM Switch Debug Commands
debug platform sw-bridge
debug platform sw-bridge
Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
bridging function. Use the no form of this command to disable debugging.
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
command.
Related Commands
broadcast
Display broadcast-data debug messages.
control
Display protocol-packet debug messages.
multicast
Display multicast-data debug messages.
packet
Display sent and received data debug messages.
unicast
Display unicast-data debug messages.
Release
Modification
12.2(25)SE1
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.