Cisco Cisco Gigabit Ethernet Switch Module (CGESM) for HP Technical References
2-45
Cisco Gigabit Ethernet Switch Module for the HP p-Class BladeSystem Command Reference Guide
380265-002
Chapter 2 CGESM Switch Cisco IOS Commands
cluster commander-address
cluster commander-address
You do not need to enter this command. The cluster command switch automatically provides its MAC
address to cluster member switches when these switches join the cluster. The cluster member switch
adds this information and other cluster information to its running configuration file. Use the no form of
this global configuration command from the cluster member switch console port to remove the switch
from a cluster only during debugging or recovery procedures.
address to cluster member switches when these switches join the cluster. The cluster member switch
adds this information and other cluster information to its running configuration file. Use the no form of
this global configuration command from the cluster member switch console port to remove the switch
from a cluster only during debugging or recovery procedures.
cluster commander-address mac-address [member number name name]
no cluster commander-address
Syntax Description
Defaults
The switch is not a member of any cluster.
Command Modes
Global configuration
Command History
Usage Guidelines
This command is available only on the cluster command switch.
A cluster member can have only one cluster command switch.
The cluster member switch retains the identity of the cluster command switch during a system reload by
using the mac-address parameter.
using the mac-address parameter.
You can enter the no form on a cluster member switch to remove it from the cluster during debugging or
recovery procedures. You would normally use this command from the cluster member switch console
port only when the member has lost communication with the cluster command switch. With normal
switch configuration, we recommend that you remove cluster member switches only by entering the no
cluster member n global configuration command on the cluster command switch.
recovery procedures. You would normally use this command from the cluster member switch console
port only when the member has lost communication with the cluster command switch. With normal
switch configuration, we recommend that you remove cluster member switches only by entering the no
cluster member n global configuration command on the cluster command switch.
When a standby cluster command switch becomes active (becomes the cluster command switch), it
removes the cluster commander address line from its configuration.
removes the cluster commander address line from its configuration.
mac-address
MAC address of the cluster command switch.
member number
(Optional) Number of a configured cluster member switch. The range is 0
to 15.
to 15.
name name
(Optional) Name of the configured cluster up to 31 characters.
Release
Modification
12.2(25)SE1
This command was introduced.