Cisco Cisco MGX 8880 Media Gateway Release Notes
23
Release Notes for Cisco MGX Route Processor Module (RPM-XF) for PXM45-based Switches Release 5.4.00
OL-11808-01
Features Not Supported in Cisco IOS Release 12.3(11)T7
•
Before adding redundancy, you must ensure that E:RPM/auto_config_slot# is created. This may
require that you log in to the primary card through the command line and manually add boot config
e:auto_config_slot# followed by a write mem command.
require that you log in to the primary card through the command line and manually add boot config
e:auto_config_slot# followed by a write mem command.
•
Executing the switchcc command back-to-back using the switchredcd command can cause
problems. We recommend allowing at least 5 seconds between switchredcd and a switchcc.
problems. We recommend allowing at least 5 seconds between switchredcd and a switchcc.
•
Cisco IOS software on a standby card should be the same or later release than the active RPM-XF
card release.
card release.
•
If the card is in a redundancy group, do not boot the card from an image on a TFTP server. Boot the
card from image in bootflash or PXM disk only.
card from image in bootflash or PXM disk only.
•
Do not configure the standby RPM-XF.
Features Not Supported in Cisco IOS Release 12.3(11)T7
The following features are not supported in Cisco IOS Release 12.3(11)T5:
•
LSC redundancy
•
Modem connectivity on auxiliary port
•
MPLS TE tunnels on ATM interfaces
•
Online insertion and removal (OIR) of back cards without interfaces in shutdown mode
•
Per-packet load-balancing
•
ROM monitor (ROMmon) Xmodem functionality does not support the speed option
•
RPM-PR to RPM-XF upgrade
•
Virtual circuit (VC) merge
Network Management Features
Network management features are detailed in the Release Notes for Cisco WAN Manager 15.1.50 at:
SNMP MIB
Cisco IOS MIBs are not part of the MGX Release 5.4.00 SNMP MIB bundle; they are part of the latest
Cisco IOS Release.
Cisco IOS Release.
New and Modified Commands in Cisco IOS Release 12.4(6)T1
The following commands, not previously documented, are modified in Cisco IOS Release 12.4(6)T1:
•
•