Cisco Cisco Customer Voice Portal 8.0(1)
from the Call Server, it needs to match an outbound dial peer in order for the call to succeed.
For example:
For example:
dial-peer voice 1050 voip
destination-pattern 1...
voice-class codec 1
session target <your h323 destination>
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad
!
Step 2
Enable the Unified CVP survivability service to execute the H,323 RF transfers by using the
following parameter:
following parameter:
param icm-rf 1
. The default RF number in the Unified CVP survivability
script can be changed using
param rf-number <new RFnumber>
.
Configuring H.323 Blind Transfer in H.323 Service
Step 1
Change the default RF number (88) using the Unified CVP VBAdmin
setRFN <new
RFNumber>
parameter.
Note: Do not append any characters to the Temp connect using Label+corrId even if
h323.rftransfer is set to "y" or "Y" in the Unified ICME script.
h323.rftransfer is set to "y" or "Y" in the Unified ICME script.
Configuration and Administration Guide for Cisco Unified Customer Voice Portal Release 8.0(1)
333
Chapter 8: Administering the Unified CVP H.323 Service
Performing H.323 Blind Transfers