Cisco Cisco Unified Customer Voice Portal 10.0(1)

You should see the status message Reset request was sent successfully. Click Close to close the
Device Reset window.

Repeat the above steps to add a trunk to the CVP call server (for the comprehensive exercises).
Substitute the following information for step #7:

a.

In the Trunk Information section:

Device Protocol: SIP Trunk

b.

In the Device Information section:

Device Name: CVP_Trunk

Description: Trunk to CVP for comprehensive exercises

Device Pool: Select Default from the drop-down menu.

c.

In the SIP Information section:

Destination Address: Enter the IP address of the all-in-one-box CVP call server.

SIP Trunk Security Profile: From the drop-down menu, select Non Secure SIP Trunk Profile.

SIP Profile: From the drop-down menu, select Standard SIP Profile.

d.

Click Save and after the reset prompt click Reset and use the Device Reset window to
perform the reset operation.

To check the new entries, click Device > Trunk. The table entries should show your newly
defined trunks. (You may have to click Find to display the new truck information.) The Route
Pattern area is blank at this point. You will add route patterns (dial numbers) in the next task.

Getting Started with Cisco Unified Customer Voice Portal Release 8.0(0)